Welcome "Modelers" to Air Tractor Country... where AG Aviation is the only way to fly! NEWS FLASH... Tail Wheel Supplier...We have finally located a supplier for the Tail Wheel Assembly with sizes which work on the AT502B-100, and the AT502-72.  The contact information is listed on the CONTACT US page.  Click to Enlarge AIR TRACTOR 502-72 72% OF THE AT502B-100 A totally new design...The 72" wingspan version of the Air Tractor AT502 is flight tested, and shipping.  Prototype "ONE" now has around 180 flights, and is performing great!  For more information, delivery costing, photos, etc. please go to the CONTACT US page... See you there!   100" Wingspan AT502B-100 The Air Tractor shown above is a 1/6 scale model of the Full Scale Air Tractor 502B.  Wingspan is 100" Weight is 16 pounds Engine is a Moki 1.8 Glow. Covering is Cub Yellow Monokote Trim is Sapphire Blue Monokote Canopy is from Stan's Fibertech Cowling is from Stan's Fibertech Landing Gear is from TNT Landing Gear Wing Tube is from TNT Landing Gear Tail Wheel Assembly from JR Hobby Hardware See Contact us page for contact information on suppliers listed above   We are offering a Laser cut Short kit for $110.00, and Computer drawn Plans are $45.00.  Shipping, and Handling is currently running $23.00 for most locations of the USA.  SHORT KIT INCLUDES:  Fuselage Formers, Wing Ribs, Flap Ribs, Aileron Ribs, Fin Ribs,Stab Ribs, and Rudder Ribs.  Plywood Side Panel Doublers, Plywood Rear Side Doublers, Firewall, Fin  Posts, Ply Instrument panel, Rudder and Fin Top pieces. Plywood side Doublers contain holes for Wing Tube, Wire Tubes, Wing Bolts, and Wing Dowels which automatically set wing incidence.  R1 Root Ribs contain same hole pattern for "no error" in wing alignment. LOW PASS... Photo by Bobby Wilkinson 11-7-2004 NEW PHOTOS - AT502B-100 Click on the thumbnails below to see the AT502B-100 in action at the Alabaster, Alabama Air Show.  This event was held at their NEW flying site in April 2006.